To Next Page

To Previous Page

Commands listed in alphabetical order

Syntax

TRIGger:{A|B}

:BUS:B<x>:LIN:IDentifier:VAL ue <QString>

TRIGger:{A|B}:BUS:B<x>:LI N:IDentifier:VALue?

Arguments

<QString> is the binary address string used for LIN trigger if the trigger

condition is ID or IDANDDATA.

Examples

TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE "110010" sets the identiﬁer

value to 110010.

TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE? might return

TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE "XXXXXX" indicating the

identiﬁer value is XXXXXX.

TRIGger:{A|B}:BUS:B<x>:MIL1553B:COMMAND:ADDRess:HIVALue

This command sets or queries the high value when triggering on command word

addresses for a MIL-STD-1553 bus. The bus number is speciﬁed by x. The

trigger condition must be set to COMMAND, and the address qualiﬁer must be

INrange or OUTrange.

Conditions

Requires the SR-AERO Triggering and Analysis application

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:MI L1553B:COMMAND:ADDRess:HIVALue

TRIGger:{A|B}:BUS:B<x>:MI L1553B:COMMAND:ADDRess:HIVALue?

Arguments

<QString> is the address value.

Examples

TRIGGER:A:BUS:B1:MIL1553B :COMMAND:ADDRESS:HIVALUE "X1000"

sets the value to X1000.

TRIGGER:A:BUS:B1:MIL1553B :COMMAND:ADDRESS:HIVALUE? might return

"XXXXX", indicating that the value is XXXXX.

TRIGger:{A|B}:

BUS:B<x>:MIL1553B:COMMAND:ADDRess:QUALiﬁer

This command sets or queries the qualiﬁer to be used when triggering on

command word addresses for a MIL-STD-1553 bus. The bus number is speciﬁed

by x. The trigge

r condition must be set to COMMAND.

2-814 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 User Manual

Questions and Answers: