Tektronix MSO56 User Manual

Commands listed in alphabetical order
Syntax
BUS:B<x>:DISp
lay:LAYout {BUS|BUSANDWAVEFORM}
BUS:B<x>:DISplay:LAYout?
Arguments
BUS specifies displaying the bus form only.
BUSANDWAVEFORM specifies displaying the b us form and the constituent source
waveform(s). This argument is not available for some bus types and some bus
configurations
Examples
BUS:B1:DISplay:LAYout BUS specifies displaying the bus form only.
BUS:B1:DISplay:LAYout? might return :BUS:B1:DI SPLAY:LAYOUT BUS
indicating the bus will be displayed without displaying its constituent source
waveform(s).
BUS:B<x>:ETHERnet:DATAMINUSTHRESHold
This command sets or queries the Ethernet D- source threshold for the specified
bus. This threshold only applies when the Ethernet signal type is single ended.
The bus is specified by x.
Conditions
Requires option SR-ENET.
Group
Bus
Syntax
BUS:B<x>:ETHERnet:DATAMINU STHRESHold <NR3>
BUS:B<x>:ETHERnet:DATAMINU STHRESHold?
Related Commands
BUS:B<x>:ETHERNET:SOUrce:DMINus, BUS:B<x>:ETHERNET:SOUrce:
DPLUs, BUS:B<x>:ETHERnet:SIGNALTYpe
Arguments
<NR3> is the Ethernet D- source threshold for the specified bus.
Examples
BUS:B3:ETHERNET:DATAMINUST HRESHOLD 250.0E-3 sets the Bus 3 Ethernet
DATA Minus source threshold to 250.0000 mV.
BUS:B2:ETHERNET:DATAMINUST HRESHOLD? might return
BUS:B2:ETHERNET:DATAMINUST HRESHOLD 1.0 indicates the Bus 2
Ethernet D- source threshold is set to 1.0 V.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-133

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English