Commands listed in alphabetical order
Syntax
TRIGger:{A|B}
:BUS:B<x>:RS232C:DATa:SIZe <NR3>
TRIGger:{A|B}:BUS:B<x>:RS 232C:DATa:SIZe?
Arguments
<NR3> specifies the data size in bytes.
Examples
TRIGGER:A:BUS:B1:RS232C:D ATA:SIZE 3 sets three bytes data size for the
RS-232C bus B1 trigger.
TRIGGER:A:BUS:B1:RS232C:D ATA:SIZE? might return
:TRIGGER:A:BUS:B1:RS232C: DATA:SIZE 2, indicating that the
data size for the RS-232C bus B1 trigger is set to two bytes.
TRIGger:{A|B}:BUS:B<x>:RS232C:DATa:VALue
This command sets or queries the data address string used for the RS-232 bus
trigger when the trigger condition is set to Data. The bus number is specified
by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:RS 232C:DATa:VALue <QString>
TRIGger:{A|B}:BUS:B<x>:RS 232C:DATa:VALue?
Arguments
<QString> specifies the address value. The argument is a string of 0, 1, or X
representing a binary number.
Examples
TRIGGER:A:BUS:B1:RS232C:D ATA:VALUE "011XX11" sets the data address
string used for the RS-232 bus trigger to 011XX11.
TRIGGER:A:BUS:B1:RS232C:D ATA:VALUE? might return
:TRIGGER:A:BUS:RS232C:DAT A:VALUE "XXXXXX01", indicating
that the data address string used for the RS-232 bus tr i gger is set to "XXXXXX01"
TRIGger:{A|B}:BUS:B<x>:SPI:CONDition
This command specifies the trigger condition for a SPI trigger. The bus number is
specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
2-832 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
