After Installation
Do these tasks after installation is completed.
1. Perform the SMC List Card Save (SP Text Mode) function to save the SMC list as CSV files to the
SD-card inserted into the operation panel SD-card slot. (p.636)
2. Upload the NVRAM contents to an SD card.
• Insert an SD card into SD card Slot 2 of the machine.
• Do SP5-824 (NVRAM Data Upload) to upload the contents of the NVRAM to the SD card.
• Keep the SD card is a safe place.
• SP5-824
• Touch [EXECUTE] to upload the UP and SP mode data (except for counters and the serial
number) from NVRAM on the control board to an SD card.
• Note: While using this SP mode, always keep the front cover open. This prevents a software
module accessing the NVRAM during the upload.
Moving the Machine
• The scanner stand and scanner unit assembly is extremely top heavy and can tip over easily. Never
attempt to move the machine with the scanner stand detached from the main unit.
Observe the following precautions when moving the machine to another location in the same room or in
the same building:
• Two people are required to push and move the machine to a new location.
• To prevent ink spillage, never tilt the machine. A new machine with no ink in it can be tilted 70°
from the horizontal to load it onto a truck or into an elevator. However, a used machine with ink in
it should never be tilted more than 45° from the horizontal.
• Make sure that the four screws that connect the scanner stand to the main unit stand are attached
and securely fastened.
• Make sure that the four casters of the main unit stand and scanner stand are unlocked before you
try to move the machine.
• It is not necessary to remove the ink cartridges.
• Position your hands at the base of the main unit and then push it slowly to the new location.
• Before shipping the main unit, pack and tape some shipping material against the carriage to
prevent the carriage from slipping out of position.
• Make sure that the main unit is packed level and strapped securely.
Main Machine Installation
147
To Next Page
Loading...
Need help?
General