16. As soon as the printer receives the data, it will be stored on the SD card automatically
with no print output. Nothing is displayed on the screen, indicating that a Card Save
operation was successful.
17. Press "Stop" button to exit Card Save mode.
18. Change the Bit Switch Settings back to the default 00000000. Press the "#" button in the
numeric keypad to register the changes.
19. Remove the SD card after the main power switch is turned off.
Error Messages
Card Save error messages:
• Init error: A card save process (e.g. card detection, change to kernel mode) failed to initialize.
• Card not found: Card cannot be detected in the slot.
• No memory: Insufficient working memory to process the job.
• Write error: Failed to write to the card.
• Other error: An unknown error occurred.
If an error occurs, pressing "OK" will cause the device to discard the job and return to the ready state.
Card Save Function
653
To Next Page
Loading...
Need help?
General