180
Operating systems
COMAND navigation system* (dynamic route guidance with RDS-TMC)
An RDS-TMC radio station transmits free-
of-charge RDS-TMC traffic reports in addi-
tion to the radio programme. COMAND can
receive the RDS-TMC traffic reports and
take them into consideration for dynamic
route guidance. The navigation system is
thus able, for example, to guide you around
a traffic jam.
There may be differences between the re-
ports received and the actual traffic situa-
tion.
왘 To switch on: select the “Dynamic
route” route type
1
.
Proceed as described in the “Selecting
the route type” section (
컄 page 145).
왘 To switch off: select the “Fastest
route” or “Short route”.
Proceed as described in the “Selecting
the route type” section (
컄 page 145).
i COMAND calculates a new route if you
change the route type setting with route guid-
ance active.
If you change the route type setting when route
guidance is inactive, COMAND uses the new set-
ting for the next route guidance.
The RDS-TMC status indicator is located
in the lower right-hand corner of the
COMAND display.
1 RDS-TMC status indicator
Here you can see the displays which are
possible.
1 An RDS-TMC radio station can be re-
ceived
2 Dynamic route guidance is switched on
3 There is an RDS-TMC traffic report re-
garding slow-moving traffic on the
route (the letters TMC are in yellow)
4 There is an RDS-TMC traffic report re-
garding a traffic jam on the route (the
letters TMC are in red)
5 There are warnings concerning the
route (e.g. motorist driving against the
traffic on the motorway, animals on the
carriageway)
COMAND navigation system*
(dynamic route guidance with
RDS-TMC)
Switching dynamic route guidance
on/off
1 RDS-TMC and dynamic route guidance are not
available in all countries.
RDS-TMC status indicator
P68.20-5083-31
P68.20-5188-31
To Next Page
Loading...
Need help?
General
