200
Operating systems
COMAND system settings
Switching the display on or off
왘 To switch off: select “Vehicle” “Dis-
play off”.
왘 To switch back on: turn ymz, slide
qmr, slide omp or press n.
Setting daylight/night display
왘 Select “Vehicle” “System settings”
“Display”.
왘 Select “Day design” or “Night design”
or “Automatic”.
i In the “Automatic” setting, COMAND analy-
ses the automatic vehicle light sensor and
switches between the display designs automati-
cally.
Setting the time
i The correct time must be set for the follow-
ing navigation system* functions to operate cor-
rectly:
앫 Route guidance on routes with time-depend-
ent traffic guidance
앫 Calculation of expected time of arrival
왘 Select “Vehicle” “System settings”
“Time” “Time”.
왘 To select hour or minute(s): slide
omp.
왘 To set the value: turn ymz or slide
qmr.
왘 To store the setting: press n.
i The increment value for setting the minutes
depends on the situation. It is 30 minutes if your
vehicle is equipped with a navigation system*
and GPS reception is available. It is one minute if
there is no GPS signal or if your vehicle is not
equipped with a navigation system*.
COMAND system settings
Systems setting menu overview
Display Time Text reader Linguatronic* Language Favourites Services* Reset
Display
settings
Time settings Text reader
settings
Linguatronic*
settings
Language
settings
Assign pro-
grammable
button
Bluetooth* set-
tings
Reset
COMAND to
factory settings
Display settings Time settings
To Next Page
Loading...
Need help?
General
