203
Operating systems
COMAND system settings
왘 Select “Yes” or “No”.
If you select “No”, the voice training
will be cancelled. The data from the
first part is stored automatically.
If you select “Yes”, the second part will
begin.
Voice training is completed at the end of
the second part. You will see a message to
this effect. The data from the second part
is stored automatically.
Exiting during the first or second part of
voice training
왘 Select “Cancel”.
A prompt appears asking whether you
really do wish to exit.
왘 Select “Yes” or “No”.
If you select “Yes”, the voice training
will be cancelled. The data from the
part at which you exited is not stored.
If you select “No”, the part at which you
stopped begins again.
Deleting existing voice training data
왘 Select “Vehicle” “System settings”
“Linguatronic” “Delete individual-
isation”.
A prompt appears asking whether you
really do wish to delete.
왘 Select “Yes” or “No”.
The voice training data will either be
deleted or not, depending on your se-
lection.
왘 Select “Vehicle” “System settings”
“Language”.
The language list appears. The R dot
indicates the current setting.
왘 To change the setting: select the de-
sired language.
The language is set.
1 Programmable button
You can assign the following predefined
functions to the P programmable but-
ton:
앫 “Rear window blind”*
You can use the programmable button
to extend or retract the rear window
blind.
앫 “Display off”
You can use the programmable button
to switch the COMAND display on or
off.
Setting the system language
Assigning the programmable button
(favourites)
P68.20-3459-31
To Next Page
Loading...
Need help?
General
