GENERAL TROUBLESHOOTING
SM 4-17 J001/J003
Trouble-
shooting
Failure to feed.
Cause 1:
Paper skewed immediately after loading, before paper out (last sheet), or after
removing a paper jam.
Solution 1:
Remove the paper from the paper tray. Fan it to remove static cling. Tap the
edge of the stack on a flat surface to align the edges, and load it again.
Before loading the paper again:
Make sure the paper is approved for use with this printer. For more, see the
Operating Instructions or the last section of the Service Manual
“Specifications”.
Make sure the paper is free of curl, creasing, etc. or any other deformity.
Make sure the side and end fences of the paper cassette are set at the
correct positions.
Make sure that the top of the stack does not exceed the load limit mark on the
side of the cassette.
Cause: 2
The paper cassette is making a strange noise because it is not installed
completely.
Solution 2:
Pull the paper cassette out. Make sure the paper is loaded correctly. Confirm
that there is no paper inside the printer. Insert the paper cassette completely.
Cause 3:
The correct paper was not used for the print job, or the paper was not loaded
correctly.
Solution 3:
Check the selection of the type of paper in the printer driver (transparency, ink
jet, plain paper, etc.). Confirm that the same type of paper is loaded correctly
in the printer.
To Next Page
Loading...
Need help?
General
