Component Removal
J007/J010/J011 3-26 SM
3.4.8 VERTICAL ENCODER SENSOR
Work carefully to avoid bending or scratching the edge of the vertical encoder
sensor wheel.
1. Unfasten the vertical encoder PCB by removing screws [1], [2] (
x2).
2. Disconnect and remove the vertical encoder sensor board and sensor (
x1)
3.4.9 VERTICAL ENCODER WHEEL
1. Remove the spring [1] to release tension on the feed belt (
x1).
2. Remove the flexible plastic clamp [2] from the tip of the shaft.
To Next Page
Loading...
Need help?
General
