Ricoh J011 User Manual

670 pages

To Next Page

To Previous Page

INSTALLATION PROCEDURE

SM 1-7 J001/J003

Installation

1.2 INSTALLATION PROCEDURE

1.2.1 ACCESSORY CHECK

Check the accessories and their quantities against this list:

Description Q’ty

1. USB Cable ............................................................................. 1

2. Setup Guide........................................................................... 1

3. Printer Driver Installer & Manual CD-ROM ............................ 1

4. Print Cartridge (Yellow).......................................................... 1

5. Print Cartridge (Magenta) ...................................................... 1

6. Print Cartridge (Cyan)............................................................ 1

7. Print Cartridge (Black) ........................................................... 1

8. Duplex Unit *1........................................................................ 1

Registration Card................................................................... 1

Warranty Card ....................................................................... 1

*1 The J003 is shipped with the Duplex Unit installed. The Duplex Unit is optional for the J001.

CAUTION

Always set the machine off and unplug the machine before you do the

following procedures.

G707I905.BMP

CÓPIA NÃO CONTROLADA

Other manuals for Ricoh J011

C
Christopher SmithAug 21, 2025
What to do if I see 'SC993 High voltage leak' on my Ricoh All in One Printer?
- K
  Kaitlyn TownsendAug 21, 2025
  If your Ricoh All in One Printer shows the error 'SC993 High voltage leak', it means the leak detection signal went ON and didn't change, possibly due to ink or condensation on the transport belt. First, try cycling the printer off and on. Then, raise the top cover and inspect the transfer belt surface. You can also run the De-Condensation function by pushing [Menu], selecting "Maintenance"> "De-Condensation" to feed 3 sheets of blank paper through the paper path. Clean any ink from the transport belt. If the issue persists, the HVPS pack may need replacement.
J
James CollinsAug 19, 2025
What to do if my Ricoh All in One Printer says 'SC978 Left ink collection tank'?