Installation Procedure
J007/J010/J011 1-10 SM
To prevent damage to the printer, always carry the printer as shown above.
Never lift the printer with your hand under the duplex unit in the back or under the
paper cassette in the front.
1.3.4 INSTALL THE PRINT CARTRIDGES
If ink gets on the skin, wash the affected area immediately with soap and cold
running water.
If ink gets into the eyes, immediately flush the eyes with cold running water. If
there are signs of irritation or other problems, seek medical attention immediately.
If ink is swallowed, drink a strong solution of cold water and table salt to induce
vomiting. Seek medical attention immediately.
Ink is difficult to remove from fabric. Work carefully to avoid staining clothing when
performing routine maintenance or replacing cartridges.
Always store ink cartridges out of the reach of children.
1. Unpack the four cartridges provided with the printer.
The "Starter" ink cartridges provided for installation contain a limited supply of
ink. Make sure that you have an additional set of ink cartridges available for
replacement before you use the printer.
Use only Ricoh Print Cartridges designed for use with this printer.
2. Open the right front cover.
To Next Page
Loading...
Need help?
General
