168
Frame Memory Clip Operations
Chapter 7 Frame Memory
back. This is the status when the [Ancillary Enable]
button in the Frame Memory >Clip menu is set to On.
This is the status after a clip recording operation.
This status information is saved in a file, and is followed
when the file is recalled.
Frame memory clip settings
For frame memory clips, you can make the following
settings using a menu or device control block (trackball/
search dial/joystick).
• Start point
• Stop point
• Loop On/Off
The above settings can be saved in a snapshot register as
snapshot attributes, and recalled.
Frame Memory Clip
Operations
During playback of a frame memory clip of the pair
assigned to either of the target FM selection buttons (see
page 169), frame memory operations may not be
performed properly.
Carry out frame memory operations after stopping clip
playback.
Preparations for Operation
The preparations for using a frame memory clip (hereafter,
a “clip”) are the same as for a still image operation.
For details, see “Preparations” (page 158) and
“Selecting Outputs and Target Frame Memory” (page
161).
Recalling Clips
Recalling a clip
You can recall a clip from each of frame memories 1 to 8.
1
In the Frame Memory menu, select VF2 ‘Clip’ and
HF1 ‘Recall.’
The Recall menu appears. (See following figure)
• When [Pair] is set to On, only pair files (sets of main
file and sub file) are shown.
• When [Pair] is set to Off, both of single files and pair
files are shown.
Notes
To Next Page
Loading...
Need help?
General