420
Snapshot Operations in the Menus
Chapter 14 Snapshots
2
As required, change the bank (see page 420).
3
Press the button for the number or name you want to
recall.
This recalls the snapshot, and the button you pressed
lights green.
Saving a snapshot
1
Display the Misc >Snapshot menu.
2
Set the state you want to save as a snapshot.
3
Press [Store].
The button lights amber.
4
As required, change the bank (see page 420).
5
Press the button for the number or name you want to
save.
This saves the snapshot, and the button goes off.
Changing the bank
Change the combination shown on the memory recall
buttons (the bank).
1
Press [Bank Sel].
2
Select the bank in the numeric keypad window.
For example, to show the numbers or names
corresponding to registers 11 to 20, select “1” in the
numeric keypad window.
Applying attributes
To apply an attribute to the snapshot represented by a lit-
green memory recall button, use the following procedure.
1
To apply the cross-point hold attribute, in the
<Attribute Xpt Hold> group select the appropriate bus.
A setting in the Setup menu determines whether key
disable is applied to cross-point hold or not.
For details, see “Selecting the Bank to Make the
Settings” (page 536).
2
Select the fol
lowing attributes i
n the <Attribute>
group as required.
Effect Dissolve: Apply effect dissolve.
Auto Transition: Apply auto transition.
GPI Output: Apply GPI output. When this is
selected, select the GPI number with the knob.
Deleting a snapshot
1
In the Misc >Snapshot menu, press [Delete].
The button lights amber.
2
As required, change the bank.
3
Press the button for the number or name you want to
delete.
This deletes the snapshot, and the button you pressed
goes off.
Renaming a snapshot register
1
In the Misc >Snapshot menu, press [Rename].
The button lights amber.
2
As required, change the bank.
3
Press the button for the number you want to rename.
A keyboard window appears.
4
Enter the register name, and press [Enter].
The new name appears on the memory recall button.
Notes
To Next Page
Loading...
Need help?
General