485
System Maintenance (Maintenance Menu)
Chapter 18 System Setup (System)
1
In the System >Maintenance >Setup Operation Lock
menu, press [Lock].
A keyboard window appears.
2
Enter the password.
If the password is correct, the lock is released, and the
padlock icon disappears.
Changing the lock password
1
In the System >Maintenance >Setup Operation Lock
menu, press [Change Password].
A confirmation message appears.
2
Press [Yes].
A keyboard window labeled “Old Password” appears.
3
Enter the old password, and press [Enter].
If the password is correct, a keyboard window labeled
“New Password” appears.
4
Enter the new password, and press [Enter].
A keyboard window labeled “New
Password(Confirm)” appears.
5
Enter the new password once more for confirmation,
and press [Enter].
If the password is correct, the password change
completed message appears.
6
Press [OK].
Selecting an opened setup menu for
locking
With the menu you want to lock open, press [Lock Item
Select] button at the lower left.
The [Lock Item Select] button turns red, and a padlock
icon appears.
This selection is reflected in the lock candidate list in the
Setup Operation Lock menu.
If there are already one or more locked menus, selection of
lock candidates is not possible.
In this case, the indication of the [Lock Item Select] button
changes as follows.
If you want to select lock candidates, first remove the lock
in the Setup Operation Lock menu.
Locking File Loading Operations
You can inhibit load operations for a specified file
category.
1
In the System >Maintenance menu, press [File Load
Lock].
The File Load Lock menu appears.
The status area shows a list of file category numbers,
category names, and the lock status.
Subsequent lock operations apply to the category
selected here.
Notes
VF button
Lock Item Select button
HF button
When the displayed
menu is locked
When a menu other
than the displayed
menu is locked
To Next Page
Loading...
Need help?
General