279
Applying Special Effects (Nonlinear Effect Settings)
Chapter 11 DME Operations
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic wave
7 (MELT1): Melting wave 1
8 (MELT2): Melting wave 2
To make the melting part stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
Character Trail Settings
You can set the effect starting position, the degree of
expansion, the slant angle of the effect region, and trail
direction, the degree to which the image disappears, the
trail type and amount of stardust, and other parameters.
To apply the Character Trail effect
With the Character Trail menu displayed, set the following
parameters.
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
To make the tip of the swirl stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Density Degree to
which image
disappears
0.00 to 100.00
2 Random Degree to
which pixel
positions
become
more
randomized
further from
the center
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Transition Position where
effect starts
–8.000 to
+8.000
a)
–32.000 to
+32.000
b)
2 Expand Degree of
expansion
0.00 to 100.00
3 Trans Angle Angle of
slanting in
effect region
–8.000 to
+8.000
4 Trail Angle Direction of trail –100.00 to
+100.00
Knob Parameter Adjustment Setting values
1 Density Degree to
which image
disappears
0.00 to 100.00
2 Random Trail type and
amount of
stardust
0.00 to 100.00
To Next Page
Loading...
Need help?
General