~.:~
3.
To prevent damage and keep foreign matter out,
cover
the
disconnected connector and pipe end with
plastic bags
[1].
QUICK CONNECT FITTING
INSTALLATION
NOTE:
• Always replace the retainer with the same
manufacturer's item that was removed.
•
Do
not bend or twist fuel feed hose.
1.
Press the connector
[1]
onto the fuel pump joint/fuel
injector joint until the retainer [2] locks with a
"CLICK".
NOTE:
• Align the quick connect fitting with the pipe.
If it
is
hard to connect, put a small amount of engine
oil
on
the pipe end.
2.
Make sure the connection
is
secure; check visually
and by pulling the connector.
FUEL PRESSURE NORMALIZATION
1.
Connect the fuel pump
SP
connector [1].
2.
Set the battery box
[2]
in
position, then install and
tighten the two special bolts [3] .
3.
. Connect the
negative(-)
cable
[4]
to the battery and
tighten the bolt
[5].
4.
Turn the ignition switch
ON
and engine stop switch
"0".
NOTE:
.
Do
not start the engine .
.
The fuel pump will
run
for about 2 seconds, and fuel
pressure will rise.
Repeat 2 or 3 times, and check that there
is
no
leakage
in
the fuel supply system.
5.
Turn the ignition switch OFF.
6.
Install the luggage box (page 2-25).
SYSTEM
[1]
[1]
[2]
[4]
[5]
To Next Page
Loading...
Need help?
General
