Honda PCX150 2014 User Manual

FRONT WHEEL/SUSPENSION/STEERING
NOTE:
Refer to LUBRICATION
&
SEAL POINTS (page 1-17).
For wheel bearing replacement (page 17-7).
DUST SEAL
Install the right dust seal
until it
is
fully seated.
1
RIGHT WHEEL
BEARING
(6201
U)
DISTANCE
COLLAR
WHEEL BEARING REPLACEMENT
Install the bearing remover head [1] into the bearing.
From the opposite side, install the bearing remover
shaft [2] and drive the bearing out
of
the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
[1] Remover head, 12 mm
[2] Bearing remover shaft
077 46-0050300
077 46-0050100
Pack all bearing cavities with grease.
Never install the old
Drive
in
a new left bearing [1] squarely with its sealed
bearings. Once the
side facing up until it
is
fully seated.
bearings have been
TOOLS:
removed, the
bearings must be
[2] Driver
replaced with new
[3] Attachment, 32
x
35 mm
ones.
[4] Pilot, 12 mm
077 49-0010000
07746-0010100
077 46-0040200
Install the left dust seal
until it
is
fully seated.
42 N·m (4.3 kgf·m,
31
lbf·ft)
1

Honda PCX150 2014 Specifications

General

Displacement	153cc
Bore x Stroke	58.0mm x 57.9mm
Compression Ratio	10.6:1
Fuel System	PGM-FI electronic fuel injection
Starter	Electric
Transmission	Automatic V-Matic belt drive
Rear Suspension	Twin shock
Rear Brake	Drum
Front Tire	90/90-14
Rear Tire	100/90-14
Wheelbase	51.8 inches
Front Suspension	31mm telescopic fork
Engine Type	Liquid-cooled 4-stroke single
Front Brake	Single 220mm disc with hydraulic two-piston caliper