Honda PCX150 2014 User Manual

FRONT WHEEL/SUSPENSION/STEERING
Remove the steering stem
[1]
and
lower steel balls (29
balls)
[2].
STEERING STEM
REPLACEMENT
• Always replace the steel balls and races
as
a set.
Remove the upper bearing outer race [1] using the
following tool.
TOOL:
[2] Ball race remover shaft
07GMD-KS40100
Remove the lower bearing outer race
[1]
using the
following tools.
TOOLS:
[2] Ball race remover, 34.5 mm 07948-4630100 or
07736-A01
OOOB
(U.S.A. only) and a
3/8 x 16 thread
slide
hammer
commercially
available in U.S.A.
[3] Ball race remover shaft 07GMD-KS40100
Remove the dust seal [1] from the steering stem lower
bearing inner race [2].
Remove the lower bearing inner race with a chisel or
equivalent tool being careful not to damage the stem.
Remove the washer
[3]
from the steering stem.
[1]
[2]
[2]
1

Honda PCX150 2014 Specifications

General

Displacement	153cc
Bore x Stroke	58.0mm x 57.9mm
Compression Ratio	10.6:1
Fuel System	PGM-FI electronic fuel injection
Starter	Electric
Transmission	Automatic V-Matic belt drive
Rear Suspension	Twin shock
Rear Brake	Drum
Front Tire	90/90-14
Rear Tire	100/90-14
Wheelbase	51.8 inches
Front Suspension	31mm telescopic fork
Engine Type	Liquid-cooled 4-stroke single
Front Brake	Single 220mm disc with hydraulic two-piston caliper