Honda PCX150 2014 User Manual

CYLINDER HEADNALVES
Always rotate the Ream the valve guide to remove any carbon build up
reamer clockwise before measuring the guide.
when inserting, Insert the reamer [1] from the combustion chamber side
removing and of the cylinder head and always rotate the reamer
reaming. clockwise.
TOOL:
[1] Valve guide reamer, 5.0 mm 07984-MA60001 or
07984-MA6000D
(U.S.A. only)
Inspect and reface Measure each valve guide I.D. and record it.
the valve seats
wheneverthe valve
SERVICE LIMITS: IN/EX: 5.03 mm (0.198 in)
guides are replaced Subtract each valve stem O.D. from the corresponding
(page
10
-
17
). guide I.D. to obtain the stem-to-guide clearance.
10-16
SERVICE LIMITS: IN: 0.08 mm (0.003 in)
EX: 0.10 mm (0.004 in)
If the stem-to-guide clearance exceeds the service limit,
determine if a new guide with standard dimensions
would bring the clearance within tolerance.
If
so, replace any guides as necessary and ream to fit
(page 10-16).
If the stem-to-guide clearance exceeds the service limit
with a new guide, also replace the valve.
CAM CHAIN GUIDE
Check the sliding area of the
cam chain guide [1] for
excessive wear or damage.
[1]

Honda PCX150 2014 Specifications

General

Displacement	153cc
Bore x Stroke	58.0mm x 57.9mm
Compression Ratio	10.6:1
Fuel System	PGM-FI electronic fuel injection
Starter	Electric
Transmission	Automatic V-Matic belt drive
Rear Suspension	Twin shock
Rear Brake	Drum
Front Tire	90/90-14
Rear Tire	100/90-14
Wheelbase	51.8 inches
Front Suspension	31mm telescopic fork
Engine Type	Liquid-cooled 4-stroke single
Front Brake	Single 220mm disc with hydraulic two-piston caliper