Honda PCX150 2014 User Manual

Install the caliper piston with
its opened
end
facing the
brake
pads.
DUST SEAL
PISTON SEAL
Coat new piston seals [1] with clean brake fluid and
install them into the caliper.
Coat new dust seals
[2]
silicone grease and install them
into the seal grooves
in
the.
caliper.
Coat the caliper piston
[3]
with clean brake fluid and
install them into the caliper cylinders with the open side
toward the pads.
Check the pin boots [1] and replace them if they are
hard, deteriorated or damaged.
Install the boot and pad spring
[2]
into the caliper [3].
Apply 0.4 g minimum
of
silicone grease to the inside of
the boots and install the caliper bracket
[4]
over the
caliper body.
Make sure the boot ribs are seated into the boot
grooves
in
the slide pins properly.
*:
Apply
0.4
g minimum of silicone grease
PAD SPRING
CALIPER BODY
~.
r
~
BLEED VALVE
5.4 N·m (0.55 kgf·m, 4.4 lbf·ft)
[3]
[4]
1

Honda PCX150 2014 Specifications

General

Displacement	153cc
Bore x Stroke	58.0mm x 57.9mm
Compression Ratio	10.6:1
Fuel System	PGM-FI electronic fuel injection
Starter	Electric
Transmission	Automatic V-Matic belt drive
Rear Suspension	Twin shock
Rear Brake	Drum
Front Tire	90/90-14
Rear Tire	100/90-14
Wheelbase	51.8 inches
Front Suspension	31mm telescopic fork
Engine Type	Liquid-cooled 4-stroke single
Front Brake	Single 220mm disc with hydraulic two-piston caliper