Jun 11 20:45:08 send: red alarm set, class 100 obj 112 reason 1
Jun 11 20:45:08 CIP removed
Meaning The chassisd database provides the date, time, and a component status message. The
chassisd database is dynamic. It is initialized at router startup and is maintained when
components are added or removed. The command output displays error messages that
are generated when a Connector Interface Panel (CIP) fails or is removed.
Related
Documentation
Basic Router Component Monitoring Method on page 51•
• Checklist for Monitoring the Craft Interface on page 249
• Display the Current Router Alarms on page 67
Verify Router Component Failure
Purpose To verify router component failure by performing a swap test on the component.
CAUTION: Before performing a swap test, always check for bent pins in the
midplane and check the component for stuck pins in the connector. Pins
stuck in the component connector can damage other good slots during a
swap test.
Action Perform a swap test on a component as follows:
1. Replace a failed component with one that you know works.
2. Verify the component status by using the appropriate show chassis component-name
command. If the replaced component works, the original component is defective.
3. If the replaced component does not work, remove it and check the component
midplane connector for bent pins. If the replaced component still does not work,
contact JTAC.
Related
Documentation
Return the Failed Component on page 116•
Replace a Failed Component
To return the router chassis, you need to know the chassis serial number. To display the
midplane serial number, use the following command:
user@host> show chassis hardware
Sample Output m160@host> show chassis hardware
show chassis hardwareItem Version Part number Serial number
Description
Chassis 101 M160
Midplane REV 02 710-001245 S/N AB4107
FPM CMB REV 01 710-001642 S/N AA2911
Copyright © 2012, Juniper Networks, Inc.162
M Series and T Series Routers Monitoring and Troubleshooting Guide
To Next Page
Loading...
Need help?
General
