Juniper M Series User Manual

Figure 117: Removing the TX Matrix Plus Router Craft Interface
g004571
Related
Documentation
Understanding the Craft Interface on page 252•
Locating the Craft Interface Serial Number ID Label
If the craft interface has failed or is absent, it does not appear in the hardware list output
when you use the show chassis hardware command. You must remove the craft interface
and manually locate the craft interface serial number ID label.
NOTE: The M5 and M10 router craft interfaces are part of the chassis. You
cannot remove them.
To locate the craft interface serial number ID label, do one of the following:
1.
Locating the M20 Router Craft Interface Serial Number ID Label on page 267
2.
Locating the M40 Router Craft Interface Serial Number ID Label on page 268
3.
Locating the M40e and M160 Router Craft Interface Serial Number ID Label on page 268
4.
Locating the M120 Router Craft Interface Serial Number ID Label on page 269
5.
Locating the M320 Router Craft Interface Serial Number ID Label on page 269
6.
Locating the T320, T640, and T1600 Router Craft Interface Serial Number ID
Label on page 270
7.
Locating the TX Matrix Router Craft Interface Serial Number ID Label on page 270
8.
Locating the TX Matrix Plus Router Craft Interface Serial Number ID Label on page 271
Locating the M20 Router Craft Interface Serial Number ID Label
Purpose To locate the serial number ID on the M20 router craft interface.
Action To locate the M20 router craft interface serial number ID label, look at the back of the
craft interface panel (see Figure 118 on page 268).
267Copyright © 2012, Juniper Networks, Inc.
Chapter 9: Monitoring the Craft Interface

Juniper M Series Specifications

General

Brand	Juniper
Model	M Series
Category	Network Router
Language	English