(For M7i, M10i, M40e, M120, M160, M320, T320, and T640 routers) To check the status
and temperature of the Routing Engines, use the following command:
user@host> show chassis environment routing-engine
user@host> show chassis environment routing-engine
Route engine 0 status:
State: Present Master
Temperature: 0 degrees C / 32 degrees F
Route engine 1 status:
State: Present
The command output displays the Routing Engine slot number, operating state,
temperature, and whether it is operating as the master or backup. The state can be
Present or Absent.
To check the status and temperature of a particular Routing Engine, use the following
command:
user@host> show chassis environment routing-engine slot
Related
Documentation
Routing Engine Overview on page 168•
Check the Routing Engine LEDs
To check the Routing Engine status LEDs, do one of the following:
1.
Check the M7i Routing Engine LEDs on page 180
2.
Check the M10i Router Routing Engine LEDs on page 181
3.
Check the M20 Router Routing Engine LEDs on page 182
4.
Check the M40 Router Routing Engine LEDs on page 183
5.
Check the M120 Router Routing Engine LEDs on page 184
6.
Check the M40e and M160 Router Routing Engine LEDs on page 185
7.
Check the M320 Router Routing Engine LEDs on page 186
8.
Check the T320 Router Routing Engine LEDs on page 187
9.
Check the T640 Router Routing Engine LEDs on page 187
10.
Check the T1600 Router Routing Engine LEDs on page 188
Check the M7i Routing Engine LEDs
Purpose Check the four LEDs located on the Routing Engine faceplate. A green LED labeled HDD,
a blue LED labeled MASTER, a red LED labeled FAIL, and a green LED labeled ONLINE
indicate Routing Engine status.
Action Table 42 on page 181 describes the LED states.
Copyright © 2012, Juniper Networks, Inc.180
M Series and T Series Routers Monitoring and Troubleshooting Guide
To Next Page
Loading...
Need help?
General
