Juniper M Series User Manual

CHAPTER 9
Monitoring the Craft Interface
•
Checklist for Monitoring the Craft Interface on page 249
•
Understanding the Craft Interface on page 252
•
Monitoring the Craft Interface Status on page 256
•
Viewing Craft Interface Information from the Command Line on page 258
•
Verifying Craft Interface Failure on page 259
•
Replacing the Craft Interface on page 262
•
Locating the Craft Interface Serial Number ID Label on page 267
•
Returning the Craft Interface on page 271
Checklist for Monitoring the Craft Interface
Purpose To monitor and maintain the craft interface or Front Panel Module (FPM) to ensure that
you can view the router status and perform management operations from the panel on
the front of the chassis.
Action Table 63: Checklist for Monitoring the Craft Interface
Command or ActionMonitor Craft Interface Tasks
“Understanding the Craft Interface” on
page 252
• M5 and M10 Router Craft Interface
• M20 Router Craft Interface
• M40 Router Craft Interface
• M40e and M160 Router Craft Interface
• M120 Router Craft Interface
• M320 Router Craft Interface
• T320, T640, and T1600 Router Craft
Interface
• TX Matrix Router Craft Interface
• TX Matrix Plus Router Craft Interface
“Monitoring the Craft Interface Status” on
page 256
249Copyright © 2012, Juniper Networks, Inc.

Juniper M Series Specifications

General

Brand	Juniper
Model	M Series
Category	Network Router
Language	English