Juniper M Series User Manual

Uptime 13 days, 10 hours, 36 minutes, 22 seconds
Load averages: 1 minute 5 minute 15 minute
0.22 0.06 0.02
Routing Engine status:
Slot 1:
Current state Backup
Election priority Backup (default)
Temperature 35 degrees C / 95 degrees F
CPU temperature 32 degrees C / 89 degrees F
DRAM 256 MB
Memory utilization 28 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 1 percent
Interrupt 0 percent
Idle 99 percent
Model RE-5.0
Serial ID 1000485860
Start time 2004-09-11 01:01:02 PDT
Uptime 30 days, 12 hours, 41 minutes, 15 seconds
Meaning The command output displays the operating state of both Routing Engines installed in
the router chassis, including slot number, current state, and default election
priority—master or backup. The command output also displays the Routing Engine
temperature, amount of memory, and the percentage of memory and CPU utilization.
The command output displays the Routing Engine model number, serial number ID, start
time, and total operating time.
Look at the Routing Engine LEDs by using the show chassis routing-engine command
or by looking at the component faceplate at the front of the router. The Routing Engine
has four LEDs that tell operating status: a green LED labeled HDD, a blue LED labeled
MASTER, a red LED labeled FAIL, and a green LED labeled ONLINE. Table 131 on page 536
describes the Routing Engine LED states.
Table 131: Routing Engine LEDs
DescriptionStateColorLabel
There is read/write
activity on the PC
card.
BlinkingGreenHDD
Routing Engine is
functioning as
master.
On steadilyBlueMASTER
Routing Engine is
not operational.
On steadilyRedFAIL
Routing Engine is
running normally.
On steadilyGreenONLINE
Copyright © 2012, Juniper Networks, Inc.536
M Series and T Series Routers Monitoring and Troubleshooting Guide

Juniper M Series Specifications

General

Brand	Juniper
Model	M Series
Category	Network Router
Language	English