Juniper M Series User Manual

Table 84: TX Matrix Router Three-Input 240-A DC Power Supply
LEDs (continued)
DescriptionStateColorLED
When the power supply is correctly
set to 2-INPUT mode and INPUT 0
and INPUT 1 are properly energized,
the DC OK LED indicates that the
power supply is functioning
normally.
On steadilyBlueDC OK—One per
power supply
Power supply is starting up, is not
functioning, is not properly
installed, or is not operating
properly.
Blinking
Input is receiving voltage.On steadilyGreenINPUT
PRESENT—One
per input
Input voltage is not present.Off
Power supply has exceeded
recommended temperature.
On steadilyYellowOVER
TEMP—One per
power supply
Power supply is within the
recommended temperature or the
power supply is not on.
Off
Table 85 on page 300 describes the functions of the TX Matrix Plus router DC power supply
LEDs.
Table 85: TX Matrix Plus Router Power Supply LEDs
DescriptionStateColorLabel
The power supply is functioning normally.On steadilyGreenOK
The power supply is not functioning normally.Off–
The power supply has failed.On steadilyRedFAIL
No faults have been detected for the power supply.Off–
Related
Documentation
Power Supplies Overview on page 275•
Copyright © 2012, Juniper Networks, Inc.300
M Series and T Series Routers Monitoring and Troubleshooting Guide

Juniper M Series Specifications

General

Brand	Juniper
Model	M Series
Category	Network Router
Language	English