EasyManuals Logo

Suzuki kq750 User Manual

Suzuki kq750
711 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #355 background imageLoading...
Page #355 background image
Drive Chain / Drive Train / Drive Shaft: 3A-2
Front Drive Shaft Assembly Removal and
Installation
B831G23106002
Removal
1) Drain the front differential gear oil. Refer to “Front
Differential Gear Oil Inspection in Section 0B
(Page 0B-12)”.
2) Remove the front wheel. Refer to “Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-2)”.
3) Remove the steering knuckle. Refer to “Front Wheel
Hub / Steering Knuckle Removal and Installation in
Section 2B (Page 2B-4)”.
4) Hold the inboard joint (1) of the front drive shaft and
tug the drive shaft horizontally.
NOTE
If it is difficult to remove the front drive shaft
from the front differential gear case, use the
suitable tool.
Installation
Install the front drive shaft assembly in the reverse order
of removal. Pay attention to the following points:
Install a new circlip into the groove of front differential
gear spline.
CAUTION
!
The removed circlip must be replaced with a
new one.
Apply grease to the spline of the front drive shafts and
install the front drive shafts to the front differential gear
case.
: Grease 99000–25160 (Water resistance
grease)
CAUTION
!
Be careful not to damage the front differential
gear case oil seals.
NOTE
After installing both drive shafts, make sure
the stopper rings are seated properly by
pulling both inboard joints lightly.
Install the steering knuckle. Refer to “Front Wheel
Hub / Steering Knuckle Removal and Installation in
Section 2B (Page 2B-4)”.
Install the front wheel. Refer to “Front / Rear Wheel
Removal and Installation in Section 2D (Page 2D-2)”.
Pour the front differential gear oil. Refer to “Front
Differential Gear Oil Inspection in Section 0B
(Page 0B-12)”.
Front Drive Shaft Disassembly and Assembly
B831G23106003
Refer to “Front Drive Shaft Assembly Removal and
Installation (Page 3A-2)”.
Disassembly
CAUTION
!
Do not disassemble the wheel side joint. If
any damages are found, replace it with a new
one.
1) Remove the boot band of the differential side joint.
1
I831G1310003-01
I831G1310004-02
I831G1310005-01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki kq750 and is the answer not in the manual?

Suzuki kq750 Specifications

General IconGeneral
BrandSuzuki
Modelkq750
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals