6B-9 Steering / Handlebar:
• Connect the tie-rod ends. Refer to “Front Wheel Hub /
Steering Knuckle Removal and Installation in Section
2B (Page 2B-4)”.
• Tighten the handlebar holder nut (10) to the specified
torque.
Tightening torque
Handlebar holder nut (c): 60 N·m (6.0 kgf-m, 43.5
lb-ft)
• Install the handlebars. Refer to “Handlebars Removal
and Installation (Page 6B-3)”.
• Install the front fender. Refer to “Front Side Exterior
Parts Removal and Installation in Section 9D
(Page 9D-6)”.
• Install the front wheels. Refer to “Front / Rear Wheel
Removal and Installation in Section 2D (Page 2D-2)”.
• After installing these parts, adjust the toe. Refer to
“Toe Adjustment in Section 0B (Page 0B-22)”.
Tie-rod / Tie-rod End Removal and Installation
B831G26206006
Removal
1) Remove the tie-rod end (steering knuckle side).
Refer to “Front Wheel Hub / Steering Knuckle
Removal and Installation in Section 2B (Page 2B-4)”.
2) Remove the cotter pins, tie-rod end nut and spring
washer.
3) Remove the steering arm plate (1) with a special
tool.
Special tool
(A): 09942–72410 (Tie rod end remover)
4) Remove the other tie-rod end in the same manner as
described previously.
5) Separate the tie-rod ends (2), nuts (3), and (4) and
tie-rods (5).
CAUTION
!
The lock-nuts (3) have left-hand threads.
(c)
10
I831G1620036-02
I831G1620037-01
1
(A)
I831G1620038-01
2
2 2
2
3
4
4
5 5
3
I831G1620039-02
To Next Page
Loading...
Need help?
General
