To Next Page

To Previous Page

DISASSEMBLY AND REPLACEMENT

4 - 79

4.8.15 Transport sleeve

(11) Remove 2 seals, 4 shield bushings, the

scraper, and then take off the upper and

lower developer sleeves.

(12) Replace the oil seal pressed into 2 shield

bushings on the rear side, if necessary.

* Procedure for replacing an oil seal:

( P.4-82 "4.8.18 Procedure for

replacing an oil seal")

Fig. 4-224

(1) Remove 1 screw and then the pole position

fixing bushing on the rear side.

Fig. 4-225

(2) Remove the gear, E-ring and bearing on the

front side, and then take off the transport

sleeve.

(3) Replace 1 oil seal pressed into the front side

of the frame, if necessary.

* Procedure for replacing an oil seal:

( P.4-82 "4.8.18 Procedure for

replacing an oil seal")

Fig. 4-226

Oil seal

Shield bushing

Scraper

Pole position fixing bushingScrew

Bearing GearE-ring

Transport sleeve

Toshiba e-STUDIO556 User Manual

Other manuals for Toshiba e-STUDIO556