e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS / HDD
9 - 32
9.3 Precautions for Installation of GP-1070 and Disposal of HDD/
Board
9.3.1 Precautions for Installation of GP-1070
When installing the Data Overwrite Enabler (GP-1070), perform the following setting:
3C -> 6. Erase HDD Securely: HDD securely erasing
This setting is the overwriting method complying with DoD 5220.22-M.
1. LOW: This is the normal overwriting method. (This setting is used normally.)
2. MEDIUM: This overwriting method is more secure than LOW. The erasing time is between LOW
and HIGH.
3. HIGH: This is the most secure overwriting method. It takes the longest time to erase data.
4. SIMPLE: This is the simple overwriting method. It takes the shortest time to erase data.
9.3.2 Precautions when disposing of the HDD
[A] When disposing of ADI-HDD
When disposing of ADI-HDD, perform the following setting:
4C->1. Revert factory initial status HDD
[B] When disposing of SATA-HDD
When disposing of SATA-HDD, perform the following setting:
3C->6. Erase HDD Securely (HDD securely erasing)
This setting is the overwriting method complying with DoD 5220.22-M.
1 : LOW: This is the normal overwriting method. (This setting is used normally.)
2 : MEDIUM: This overwriting method is more secure than LOW. The erasing time is between LOW
and HIGH.
3 : HIGH:This is the most secure overwriting method. It takes the longest time to erase data.
4 :SIMPLE : This is the simple overwriting method. It takes the shortest time to erase data.
9.3.3 Precautions when disposing of the SYS board
When disposing of the SYS board, data clearing is not required since important data, such as user
information, etc. are stored in the SRAM board.
9.3.4 Precautions when disposing of the SRAM board
When disposing of the SRAM board, perform 3C -> 7:Erase SRAM Securely (SRAM securely erasing)
for security reasons.
If these codes are performed, the equipment cannot be started up.
To Next Page
Loading...
Need help?
General
