Using SP Modes
SM 5-11 D009/D011/D012/D013/D091/D092
Service
Tables
018 SRM Clear
Initializes the SRM (System Resource Manager)
settings.
019 LCS Clear Initializes the LCS (Log Count Service) settings.
020 Web Uapli
021 ECS
4. Press Execute, and then follow the prompts on the display to complete the procedure.
5. Make sure that you perform the following settings:
 Do the laser beam pitch adjustment (
p.4-29).
 Do the printer and scanner registration and magnification adjustments (
p.4-97/ p.4-101).
 Do the touch screen calibration (
p.4-104).
 Referring to the SMC data lists, re-enter any values, which had been changed
from their factory settings.
 Do SP 3-001-2 (ID Sensor Initial Setting).
6. Check the copy quality and the paper path, and do any necessary adjustments.
5.3.5 SOFTWARE RESET
The software can be reboot when the machine hangs up. Use the following procedure.
Turn the main power switch off and on.
-or-
Press and hold down
together for over 10 seconds. When the machine beeps once
release both buttons. After "Now loading. Please wait" is displayed for a few seconds the
copy window will open. The machine is ready for normal operation.
To Next Page
Loading...
Need help?
General
