Garmin G3X User Manual

190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 30-68
30.4.10.5 Step by Step On-Ground Setup
Servo Wiring Checkout
The first phase of setting up the Garmin autopilot system is to verify the proper wiring of the GSA 28
servos while on the ground.
1. If the installation is a 1-axis (roll only) autopilot, use the LRU page in configuration mode on the
PFD to configure the “Autopilot Servos” for “Roll Only”.
2. If you have installed a 2-axis (pitch and roll) autopilot, use the LRU page in configuration mode on
the PFD to configure the “Autopilot Servos” for “Pitch + Roll”.
3. If you have installed a 3-axis (pitch, roll, and yaw) autopilot, use the LRU page in configuration
mode on the PFD to configure the “Autopilot Servos” for “Pitch + Roll + YD”.
4. Go to the System Information page in configuration mode and verify the Roll, Pitch, and Yaw
servos are properly communicating with the system indicated by a green check box.

Garmin G3X Specifications

General

Display Type	LCD
Touchscreen	Yes
Power Input	10-32 VDC
Connectivity	Bluetooth, Wi-Fi (optional)
Interfaces	RS-232
GPS	Internal GPS/WAAS receiver
AHRS	Integrated AHRS
Air Data Computer	Integrated Air Data Computer
Autopilot Compatibility	Compatible with Garmin autopilots
Operating Temperature	-20°C to +55°C
Sunlight Readability	Sunlight readable display
Screen Size	10.6 inches