190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page H-115
H.4.16 XPDR Configuration Page
The Transponder Configuration Page allows selection of the installed Garmin Transponder.
1. In configuration mode, use the FMS Joystick to select the Transponder Page.
2. Use the FMS Joystick to select the applicable Transponder Type, then press the ENT Key.
3. Use the FMS Joystick to select the desired configurable item and make the desired change. Then
press the ENT Key or use the FMS Joystick to select the next item. Press the FMS Joystick to
move the cursor to the page selection menu when finished
Configurable items are as follows (note that available configurable items differ by model):
Mode S Address: Can be set to US Tail #, Octal, or Hex, as applicable. A valid Mode S Address will be
indicated by a green status box, an invalid Mode S address or other invalid Mode S configuration data is
indicated by a red X in the status box.
Tail Number: Enter the applicable aircraft tail number.
Flight ID: Can be set to Set By Pilot or Other, as applicable. If Set By Pilot is selected, the flight ID can be
entered in normal mode. Flight ID can also be set to Same As Tail Number if US Tail # was selected as the
Mode S Address.
Aircraft Type: Can be set to Unknown, Fixed Wing, or Rotorcraft, as applicable. If Fixed Wing is
selected, a field to enter the aircraft’s approximate maximum weight is displayed.
Aircraft Max Speed: Enter aircraft maximum speed.
Aircraft Length: Enter Aircraft Length.
Aircraft Width: Enter Aircraft Width.
To Next Page
Loading...
Need help?
General
