COPYRIGHT
©
2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
CHAPTER 4 IMAGE FORMATION SYSTEM
4-26 P
3.4.4 Others
COPIER>ADJUST>HV-TR>PRE-TR (entering the output adjustment
value of pre-transfer charging wire current)
Enter the value indicated on the service label if the RAM on the DC con-
troller PCB has been cleared.
COPIER>ADJUST>HV-TR>H-PRE-TR (entering the offset value of
pre-transfer high-voltage output for high-voltage unit)
Enter the value indicated on the label attached to the new high-voltage unit
if the RAM on the DC controller PCB has been cleared or the high-voltage
unit has been replaced.
COPIER>ADJUST>HV-TR>D-PRE-TR (entering offset value of pre-
transfer high-voltage output of DC controller PCB)
Enter the value indicated on the label attached to the new DC controller
PCB if the RAM on the DC controller PCB has been cleared or the DC
controller PCB has been replaced.
COPIER>OPTION>BODY>W-CLN-P
Set the intervals at which auto cleaning of the primary charging wire is ex-
ecuted in terms of the number of prints
Download Free Service Manual at http://printer1.blogspot.com
To Next Page
Loading...
Need help?
General
