ADU UNIT
3-N-12
3 DIS./ASSEMBLY
[8] Removing and Reinstalling the
Pre-Transfer Roller
Warning:
The interlock which is turned OFF when
the front right or left door opens or closes
should never be turned ON forcibly with
the ADU stand drawn out.
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Draw out the ADU stand from the main body.
(2) Remove the two springs.
(3) Open the pre-transfer jam handler to remove the
pre-transfer roller assembly.
(4) Remove the E-ring to remove the pre-transfer
roller from the shaft.
Caution: When reinstalling, pay attention to the
position of the E-ring.
(5) Reinstall the above parts following the removal
steps in reverse.
Pre-transfer jam handler
Springs
Pre-transfer roller assembly
Pre-transfer roller
Shaft
E-ring
3-N-6
To Next Page
Loading...
Need help?
General
