Konica Minolta 7155 User Manual

OTHER ADJUSTMENT
1 ADJUSTMENT
MODEL MANUAL REVISED EDITION DATE PAGE METHOD
SERVICE HANDBOOK Nov. 20017155/7165
[21] FNS Adjusting the stapling position
(stitch-and-fold) (FS-210)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
7
Rotate the stapler gears downward.
Adjust the clincher position so that the
plate on the cartridge fits smoothly into
the groove on the jig. Rotate the stapler
gear further to fit the plate in the groove
in the jig and the jig in the clincher unit
completely.
8
Tighten the four screws for each
clincher.
9
Rotate the stapler gears upwards to
remove the jig.
Caution: When removing the jig, be
careful not to break the myler
of the clincher.
10
Remove the cartridge, detach the plate,
insert the staple plate slide out on step3,
and place the cartridge to its original
position.
11
Check that the stapler operates properly.
Step Operation
Gear
Plate
Stapler
Groove
Step Operation
1
Execute stapling and check whether the
paper edge is parallel to the virtual line
connecting the two staples or whether
the amount of discrepancy is within
specification.
Spec value: within 1mm for the
amount of discrepancy
2
If the amount of discrepancy for the
booklet is out of spec, perform the fol-
lowing adjustment:
Staple
Parallel
Within
1mm
REPLACEMENT
1-123

Konica Minolta 7155 Specifications

General

Brand	Konica Minolta
Model	7155
Category	All in One Printer
Language	English