Konica Minolta 7155 User Manual

OTHER ADJUSTMENT
1 ADJUSTMENT
4
4
[35] FNS Adjusting the Magnets on Con-
veyance Guide Plate C (FS-111)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
b. Adjustment
Step Operation
5
Adhere the magnets to conveyance
guide plate A and retighten the set
screws.
6
Reassemble in opposite sequence to
removal.
7272fs1016
Magnet
(rear)
Magnet
(front)
Conveyance
Guide Plate A
Conveyance
Guide Plate B
E-ring
Gear
Step Operation
1
Open the front cover.
2
Check whether conveyance guide plate
C makes contact with the cushioning
rubber when the magnets are stuck to
conveyance guide plate D.
3
If conveyance guide plate C does not
make contact with the cushioning rub-
ber, remove the rear cover and carry out
adjustment as described below.
Step Operation
1
Detach all FNS CB (FNS control board)
connectors.
2
Remove the 2 set screws holding the
FNS CB in place. Remove the FNS CB
together with its bracket.
3
Loosen the 4 magnet-holding set screws
(two at the front and two at the back), and
move conveyance guide plate C all the
way in the direction indicated by the
arrow.
7272fs1017
Screws
Bracket
FNS CB (Finisher Control Board)
MODEL MANUAL REVISED EDITION DATE PAGE METHOD
SERVICE MANUAL Dec. 2003
7155/7165/7255/7272
1-138 ADDITION

Konica Minolta 7155 Specifications

General

Brand	Konica Minolta
Model	7155
Category	All in One Printer
Language	English