Internet ISW
2 ISW
[8] Precautions for use
1. Prior announcement to administrator
When performing the Internet ISW, be sure to contact the copierfs administrator or the like and get his/her
agreement beforehand.
Perform ISW in condition that the copier is not being used.
If the copier is being used (a job is being processed), the Internet ISW is not performed.
2. If power failure occurs during data rewriting
While ISW rewriting is in progress *17, the operation panel and sub power switch are locked. However, if the
main power goes down due to power failure or other, the copier becomes unable to start up, the same as
remote ISW. *18
This is only the problem on rewriting the image processing board. Even if errors occur on rewriting other
boards, the boards can be overwritten again with the Internet ISW.
If the copier becomes unable to start for the above reason, go to the copierfs site and rewrite the program
using the ISW tool (ISWTrans).
3. ISW of multiple programs
It is not possible with the Internet ISW to ISW several programs concurrently. Always perform ISW one by
one. If several programs must be rewritten at the same time, perform ISW from board of higher priority.
*19
When rewriting several programs, SC may occur during rewriting intervals between programs.
However, such SC will clear when all the subject programs are rewritten.
4. If ISW fails in low power mode
If ISW fails due to errors in program download, data check, and so on, the copier recovers into normal mode.
Only in low power mode, the copier reboots when ISW fails.
*17: Rewriting takes maximum one minute.
*18: No problem is cased by power failure during program downloading process.
*19: In case of the Internet ISW using the E-mail remote notification system, the sequence of transmitted ISW
designating mails and mails received by copier may change. Transmit multiple mails while ensuring
reception of completion mail or putting enough intervals.
Priority 1 FNS board (N1)
Priority 2 Print control board (C1-C5), (VideoI/F board (V))
Priority 3 Print control board (C0)
Priority 4 Image processing board (I1-I5)
Priority 5 Image processing board (I0)
MODEL MANUAL REVISED EDITION DATE PAGE METHOD
SERVICE MANUAL Dec. 2003
7155/7165/7255/7272
2-35 ADDITION
4
To Next Page
Loading...
