OTHER ADJUSTMENT
1 ADJUSTMENT
[2] Skew adjustment (Main body)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
[3] Adjusting the LCT Paper Feed Roller
Pressure (LT-412 only)
Caution: This adjustment is required when no
paper feed occurs.
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
Caution: Four weight plates come standard
with the LCT, and can be installed up
to six.
Step Operation
1
Make a copy to measure for skew.
2
Loosen the five screws securing the sec-
ond paper feed unit.
3
Rock the second paper feed unit to
adjust using the mark as a guide.
4
Retighten the five screws.
5
Make adjustments by repeating steps 2
to 4 until the skew becomes within the
specified range.
Specified range:Paper skew
±
5% or less
(Paper skew in the paper
feed direction)
Screws
Screws
Second paper
feed section
Mark
Step Operation
1
Open the top cover.
2
Remove the spring.
3
Install a weight plate above the paper
feed rollers using the two screws.
4
Make a copy to check whether paper is
fed properly.
5
If paper is not fed properly, add another
weight plate and repeat steps 5 and 6.
6
Install the spring.
Screw
Spring
Piled plate
1-100
To Next Page
Loading...
Need help?
General
