Konica Minolta 7155 - PM Count Resetting; Setting the PM Cycle

25 MODE
1 ADJUSTMENT
[5] PM Count Resetting
Care should be taken not to reset the PM count by mis-
take.
[6] Setting the PM Cycle
This function allows you to change the PM cycle.
Caution: The PM cycle is factory-set. Use this
function to change the factory-set PM
cycle.
Step Operation
1 Enter the 25 mode.
2 [Memory setting mode menu Screen]
Select " PM count".
3 [PM count/cycle Screen]
Press the key.
4 [Reset Confirmation Screen]
Press the key.The PM count is
reset and the start date is input automat-
ically.
Pressing the key closes the Reset
Confirmation screen at once.
5
Press the key to finish setting.
To cancel the new setting, press the
key.
Pressing either key will display the Mem-
ory setting mode menu Screen again.
3
COUNT RESET
YES
NO
OK
CANCEL
Step Operation
1 Enter the 25 mode.
2 [Memory setting mode menu Screen]
Select " PM count".
3 [PM count/cycle Screen]
Press the key.
4 After making sure that three digits of the
cycle value are displayed in reverse
video, enter a desired cycle value using
numeric keys.
Only the three digits of the cycle value
can be entered. The entered digits will
be shifted to the left one after another.
5 Press the key to finish setting.
To cancel the new setting, press the
key.
Pressing either key will display the Mem-
ory setting mode menu Screen again.
3
PM Cycle Setting
OK
CANCEL
1-22