36 MODE
1 ADJUSTMENT
[4] Drum Peculiarity Adjustment
Adjusting the blade set, maximum density (Dmax), dot
diameter, laser offset and gamma.
1. Select " Process adjustment" in the Adjust-
ment mode menu Screen to display the Process
adjustment mode menu Screen.
2. Press " Drum peculiarity adjustment" in the
Process adjustment mode menu Screen to dis-
play the Drum peculiarity adjustment mode
menu Screen.
3. Drum Peculiarity Adjustment consists of the fol-
lowing:
Blade setting mode
Auto maximum density adj.
Auto dot diameter adjustment
LD1 offset adjustment
LD2 offset adjustment
LD1 bias adjustment
LD2 bias adjustment
Auto gamma adjustment (1 dot)
Auto gamma adjustment (2 dot)
Cartridge set mode
4. Press the number key corresponding to the item
to be adjusted.
The adjustment screen of the selected item is
displayed.
5. When adjustment completes, the screen returns
to the Drum peculiarity adjustment mode menu
Screen.
6. Press the key in the Drum peculiarity
adjustment mode menu Screen to return to the
Process adjustment mode menu Screen.
1. Blade setting mode
In this mode, toner stuck on the drum surface
during replacement of the cleaning blade or
drum is removed to prevent damage to the drum
and cleaning blade.
Preparation: Be sure the drum unit is set.
Apply setting powder to all the sur-
face of the drum.
1
2
1
2
3
4
5
6
7
8
9
10
RETURN
Step Operation
1
Enter the 36 mode.
2
[Adjustment mode menu Screen]
Press " Process adjustment".
3
[Process adjustment mode menu
Screen]
Press " Drum peculiarity adjust-
ment".
4
[Drum peculiarity adjustment mode
menu Screen]
Press " Blade setting mode".
5
[Blade setting mode Screen]
Press the key.
Adjustment completes in about 1 second
and a complete message is displayed.
6
Press the key to return to the
Drum peculiarity adjustment mode
menu Screen.
1
2
1
Start
RETURN
1-49
To Next Page
Loading...
Need help?
General
