"config.ini" file
● The data is defined in section [T2M2N].
● The references CH_GRP_xx of the softkeys refer to the channel groups which are defined
in the "netnames.ini" file. This notation is binding.
● SKx in this case, designates the xth horizontal softkey in the channel menu.
Example
...
[T2M2N]
SK1=CH_GRP_1
SK2=CH_GRP_3
SK8=CH_GRP_15
6.6 Example: Settings for 1:N
1:N configuration
For a 1:N configuration the following requirements apply:
● A PCU with SINUMERIK Operate can be connected to a maximum of four NCUs.
● SINUMERIK Operate must be switched off on all NCUs.
● The following configuration files must be adapted:
siemens/sinumerik/hmi/template/cfg/netnames.ini
siemens/sinumerik/hmi/template/cfg/mmc.ini
This is illustrated in the following sections using an example with 1 PCU and 2 NCUs.
Example mmc.ini
[Global]
NcddeMachineNames=net, NCU840D_1, NCU840D_2
NcddeDefaultMachineName=NCU840D_1
[NCU840D_1]
ADDRESS0=192.168.214.1,LINE=14,NAME=/NC,SAP=040d,PROFILE=CLT1__CP_L4_INT
ADDRESS1=192.168.214.1,LINE=14,NAME=/PLC,SAP=0202,PROFILE=CLT1__CP_L4_INT
ADDRESS2=192.168.214.1,LINE=14,NAME=/CP,SAP=0502,PROFILE=CLT1__CP_L4_INT
ADDRESS10=192.168.214.1,LINE=14,NAME=/DRIVE_00_000,SAP=0201,
SUBNET=0046-00000000:000,PROFILE=CLT1__CP_L4_INT
ADDRESS11=192.168.214.1,LINE=14,NAME=/DRIVE_03_003,SAP=0900,
PROFILE=CLT1__CP_L4_INT
Channel menu
6.6 Example: Settings for 1:N
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 89
To Next Page
Loading...
Need help?
General
