Feedrate
SD42600 $SC_JOG_FEED_PER_REV_SOURCE = -3 Revolutional feedrate control in JOG
mode
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [X ax‐
is] = -3
Revolutional feedrate for positioning
axis X
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [Z ax‐
is] = -3
Revolutional feedrate for positioning
axis Z
Note
Ensure that the axis-specific setting data SD43300 SA_ASSIGN_FEED_PER_REV_SOURCE
are set the same.
References
● Operating:
Operating Manual, Turning/Milling, Chapter "Working with a manual machine"
● Programming:
Programming Manual, Fundamentals; Chapter "Working area limit"
8.11 User status display (OEM)
Function
User icons can be displayed in the Machine operating area in the second line in the header.
In this case, the program name is displayed in the right-hand field of the third line in the header.
Active hold conditions hide the program name.
The display of the user icons is controlled via PLC bits. The icons are provided in the form of
PNG files and stored resolution-specifically in the file system at: /user/sinumerik/hmi/
ico/ico640, etc. Maximum 16 positions are available in the header to display the user icons.
Configuration
The user icons are configured in the slmahdconfig.ini file in Section [UserIcons]. The
following data is required:
● The start address of the PLC double word with the bits to control the display of the user
icons.
● For each bit used, the file name of the icon and the position at which the icon should be
displayed.
Customizing the "Machine" operating area
8.11 User status display (OEM)
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 131
To Next Page
Loading...
Need help?
General
