Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

7.5 Configuring the SINUMERIK power up screen
You can parameterize various settings to change to the service desktop or to the SINUMERIK
welcome screen. These settings can be especially helpful if you wish to carry out diagnostics
and maintenance to a system in the headless mode.
Precondition
● In the corresponding user directory, file slstartup.ini is either not available, or there
is no slstartup.ini with different settings in a user directory with a higher priority.
If the file already exists in the corresponding user directory, then do not create a new
slstartup.ini, but instead, adapt the existing file or insert section [StartScreen]
using the appropriate keys.
Procedure
Proceed as follows to create the configuration file for the direct control key layout:
1. Open a text editor, and as character coding, set ASCII or ANSI.
2. Insert the section designation:
[StartScreen]
Service and diagnostics
7.5 Configuring the SINUMERIK power up screen
PCU Base Software (IM10)
162 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English