Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Backing up and restoring data
4.11 Bootable USB flash drive
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
105
4.11
Bootable USB flash drive
Use
You can generate a bootable Service Center (Emergency Boot System) based on Microsoft
Windows PE on a USB flash drive as preventive measure against a defect
The Ghost image is located on the SSD under:
D:\Eboot\eboot.gho
Using the same procedure, you can create a Service Center on a PG/PC. For this,
Symantec
Ghost
must be installed on the PG/PC.
Precondition
● The Windows 7 Service Desktop is active
● You have a USB flash drive (e.g. SIMATIC PC USB flash drive)
Procedure
To create a bootable USD flash drive, proceed as follows:
1. Connect the USB flash drive to a USB interface of the PCU.
2. Start Symantec Ghost, for example, by entering
Ghost32.exe in the search bar in the start
menu.
3. In Symantec Ghost, select the "From Image" command from the "Local > Disk" menu.
4. Select
D:\Eboot\eboot.gho as the source and the USB flash drive as the destination.
Result
The Emergency Boot System is installed on the USB flash drive and the data medium is
renamed to "EBOOT." The service system on the bootable USB flash drive can now be
used.

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English