2.2 Backing up and restoring the delivery condition
Before starting the actual first commissioning, you can backup the delivery condition of the
PCU base software.
Requirement
The first commissioning of the PCU 50.5 (with "unattend.xml" response file or attended) has
not been performed yet.
Procedure
To back up the delivery condition of the PCU base software, proceed as follows:
1. Start the Service Center directly after switching on the PCU 50.5 the first time, e.g. via the
Windows boot menu.
Starting the Service Center (Page 122)
2. Back up the entire C: partition as disk image at another location, e.g. at D:
\DeliveryState_PCU-Basesoftware\
See also: Create a disk image of a partition (Page 132)
Result
The delivery condition is stored as disk image at the selected location. If required, you can
move this disk image to another location later.
First create a bootable USB flash drive (Page 140) with which you can restore this disk
image (Page 134).
After you have restored the delivery condition of a PCU 50.5 with a disk image, the first
commissioning starts at the initial startup with response file or attended.
Further information
● Backing up and restoring data (Page 121)
● First commissioning of the PCU 50.5 (Page 15)
First commissioning of the PCU 50.5
2.2 Backing up and restoring the delivery condition
PCU Base Software (IM10)
18 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
