Note
Interruption of the test license
A test license period is interrupted in the following cases:
● If no axis is operated actively, e.g. during simulation mode.
● If a new valid license key is entered.
● If all non-licensed options are reset.
The test license continues when a non-licensed option is set again.
Note
End of the test license
A test license period ends when the time has expired.
No further test license can be activated on the NCU if all test license periods have expired.
4.3 Exporting license requirements
After you have determined the license requirement, you can export the data via the set-up
external storage locations.
Procedure
1. Press the "Export license requirement" softkey.
A window opens listing the storage locations that have been set up.
2. Select "USB" for example, if you export the licenses on a USB flash drive.
3. Press the "OK" softkey.
The set options, the options which are not set but are licensed options,
the license requirement and the license key are stored in an Alm file.
In addition, an Internet connection is established for the Web License
Manager.
References
A detailed description of the license management is provided in the following documentation:
CNC Commissioning Manual: NCK, PLC, drive; Chapter "Licensing"
4.4 Reading in the license key
You have the following options of communicating the license key to the control:
● Enter manually
● Read in electronically
Licensing
4.4 Reading in the license key
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 77
To Next Page
Loading...
Need help?
General
