7.6 Remote access
7.6.1 Overview
You can use a remote connection to access other devices via the network:
● Access to maintenance with prompt (SSH) via PuTTy.
● Access via VNC Viewer with all of the operating and servicing options, which are also
provided directly on the Siemens PC system.
See also
Setting up and using SSH (Page 169)
7.6.2 Searching for devices in the system network
The "sc_show_net" command shows devices available in the system network in the prompt
and offers additional information about these devices.
As both these functions rely on SNMP (Simple Network Management Protocol), only SNMP-
capable devices will be found. In the case of Windows-based devices, this depends on the
software version. If a simple call is made without any additional options, a list of the devices
found will appear showing the relevant IP address, DNS name (if known), and a short
description (module name).
sc_show_net command
This command is executed in the prompt:
Syntax: sc_show_net [-xml] [[-hw] [-tco] [-sw | -swfull] [-loc] [-panel] [-
dhcp] [-switch] | -all] [HOSTS...]
Authorization level: None
7.6.3 Display of accessible stations in SINUMERIK Operate
You can use the network diagnostics function in SINUMERIK Operate to show accessible
nodes in the system network.
Service and diagnostics
7.6 Remote access
PCU Base Software (IM10)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 165
To Next Page
Loading...
Need help?
General
