Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Commissioning the system
1.2 User administration
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
13
Starting ServiceCenter Users
Using this link on the service desktop, you can start ServiceCenter Users
as an HMI+Service
user
. In ServiceCenter Users, the boot behavior of the PCU as well as settings for the HMI
program and desktop are set globally for all users and individually for specific users.
The users are managed in the "ServiceCenter Users", so that the commissioner/service
technician no longer has to make corresponding settings directly in the registry.
1.2.2
User settings
"Global Settings"
In the ServiceCenter Users, as
HMI service user
, you set parameters under "Global
Settings" for the system behavior:
● When the PCU is booting up
● When the HMI program is starting
● With reference to the desktop
Note
The following diagrams show, as an example, an appli
cation with the
SINUMERIK
Operate software installed.
Using ServiceCenter Users
Buttons:
● Use "Exit" to quit ServiceCenter Users.
● If you press the "Reboot" button, the system immediately reboots (without prior
prompting).

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English